Team Specialist - Mold Center

Primary Responsibilities include the following. (Other duties may be assigned.)

Benching:

including deburring, buffing, cleaning, filing, etc.

• Tumbling
• Cycling molds
• Detail finish work including painting, buffing, gluing and cleaning
• General benching/deburring
• Bracket and Gen assembly
• Packaging/shipping
• Cleaning including pipe cleaning/benching guides, tumbling/cleaning tumbler, ultra-sonic cleaning
• Laser engraver operation
• Follow safe work habits and instructions
• Perform quality control inspections for all products and equipment, document results, and communicate defects as necessary.
• Follows SOP (Standard Operating Procedures) that govern all workload as well as those specific to each department and procedure. Knowledge, Skills and Abilities
• Ability to read and understand written instructions.
• Knowledge of the structure and content of the English language including the meaning and spelling of words, rules of composition, and grammar.
• Ability to effectively communicate and collaborate with others.
• Ability to demonstrate basic computer, math and computation skills.
• Ability to work in a team environment.
• Ability to prioritize and multitask.
• Regular attendance is required for the ability complete all work.
• Requires face-to-face interaction with team members, peers and management to complete all work and provide support.
• Ability to work more than 40 hours per week (overtime) if needed based on business demand.

Physical Requirements:

The requirements described here are representative to those an employee encounters while preforming the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

Requirements definitions:

Never Not performed or required. Seldom/Rare One time per hour up to times per 8-hour shift. Occasional Up to 1/3 of day; 1 x every 30 minutes; 1 - 2.6 hours Frequent 1/3 to 2/3 of day; 1 x every 2 minutes; 2.7-5.3 hours Constant Greater than 2/3 of day; 1 x every 15 seconds; 5.3-8 hours Balance Constant Worker must maintain balance to prevent falling when walking, standing, and sitting. Bend/Stoop Occasional Defined as bending body forward or laterally by bending spine at the waist, requiring use of the lower extremities and back muscles. Workers must stoop over a 28-inch-high shipper edge and reach to floor level when filling shippers. Workers must also stoop over a 34-inch bin to remove corrugate while emptying cardboard. Workers stoop over a cart at a height of 32 inches to load boxes of product onto a cart. Workers stoop when reaching horizontally 26 inches over a 36-inch-high rail to place/remove GUS panels (11 lbs.). Handle/Grasp Constant Handling/grasping includes, but is not limited to handling boxes, tools, piles of corrugate, foam, pallet jacks, tools, mo...