An Electrical Engineer designs, develops, and tests products and systems that use or produce electricity, including power generators, electric motors, radar and navigation systems, and communication systems. Works on larger electrical systems rather than small electronic products or devices.
USC/GC Job Summary We are seeking a hands-on Electrical Engineer for the development, integration, characterization, and troubleshooting of subsystem-level electrical testers. This role is highly technical and execution-focused, with a strong emphasis on practical hardware engineering. The ideal candidate should have 4-8 years of recent hands-on experience in designing and building electronics and semi-automated test systems, integrating hardware/software, and debugging complex electrical issues. Key Responsibilities Tester Development & Integration Design, build, and maintain subsystem characterization testers: Power distribution and protection Signal conditioning and measurement Control, interlocks, and safety circuits Develop custom test hardware (fixtures, wiring harnesses, test jigs) Integrate testers with: Mechanical fixtures Sensors, actuators, power electronics, embedded systems Lab and production environments Electrical Characterization & Debugging Perform subsystem electrical characterization: Voltage/current measurements Signal integrity and timing analysis Noise and grounding Troubleshoot issues in: Analog and digital electronics Power supplies, converters, motor drives Communication interfaces (I²C, SPI, UART, CAN, Ethernet, USB) Hands-On Lab Execution Execute testing in lab environments: Bring-up of testers and subsystems Debug under schedule pressure Support verification and troubleshooting Use lab equipment: Oscilloscopes, logic analyzers, DMMs, power analyzers Environmental and stress testing setups Required Qualifications Bachelor's degree in Electrical/Mechanical Engineering or related field 4-8 years of hands-on experience in: Test system development Subsystem-level electrical integration & characterization Experience in: Analog & digital circuit design/debugging Power electronics (low-voltage/high-current systems) Strong troubleshooting skills using lab tools Experience across full lifecycle: concept → build → bring-up → support Strongly Preferred Embedded subsystems Motion control systems Sensor & transducer technologies Power distribution systems Communication protocols (CAN, Ethernet, RS-232, RS-485) Preferred Qualifications Medical device experience Familiarity with industry standards Exposure to PLM tools and change management EMI/EMC knowledge in harness design Key Skills Wire harness design & routing Electrical schematics interpretation NX Routing (3D harness design) Component selection & validation Strong analytical and communication skills
