Tester

Pay Rate:

$20 - $26 per hour

Summary:

Shift Timings:

2nd shift M-F 2:00 PM - 10:00 PM (OT will vary on weekends depending on need) Training could be on 1st

Shift Responsibilities:

Perform bench work requiring use of simple limit direct reading gauges and meters Build / fabricate own setup operations on less complicated test systems Connect products to be tested to test equipment, monitor gauges and meters, verify and record results Comply with all safety requirements, including proper use of personal protective equipment and operation of equipment in a safe and competent manner Understand and meet all departmental safety objectives and goals Keep assigned work-area clean, organized, and orderly per 5S standards Perform Lean Initiatives including Continuous Improvement Lead and interpret blueprints & schematics

Requirements:

High School Diploma or GED from an accredited institution is required Minimum of three (3) years' work experience in Fuel, Hydraulic and/or Pneumatic Testing is required Must be authorized to work in the US without company sponsorship No relocation provided. Candidates must reside within 50 miles of Irvine, CA in order to be considered This position requires use of information which is subject to the International Traffic in Arms Regulations (ITAR). All accepted applications must be U.S. Persons as defined by ITAR (U.S. citizen, U.S. Permanent Resident, Political Asylee, or Refugee)

Preferred Skills:

Previous work experience in either the Aerospace, Automotive, and/or Airline Maintenance industries

Position Criteria:

Knowledge of simple math including the use of addition, subtraction, multiplication, and division of whole numbers Ability to use direct reading and fixed gauges Able to read blueprints and schematics Detailed Oriented Works Independently Continuous Improvement Follow Safety Practices & Procedures Ability to lift up to 50lbs AXEL01