Between $20.00 and

$28.00

Per Hour DOE (Depends on Experience)

Position range in Montgomery County $18.25 - $30.42 Per hour Welders needed Day and Night Shift Open

TRUBLU HR SOLUTIONS LLC

Occupation:

Welders, Cutters, Solderers, and Brazers

Location:

Magnolia, TX - 77354

Job Type:

Regular, Full Time (30 Hours or More), Permanent Employment, Other, see job description Shift

Posted:

09/17/2026

Positions available: 1

Source:

WorkInTexas

Web Site:

WorkInTexas

Onsite /

Remote:

Work onsite all of the time

Updated:

09/20/2026

Expires:

10/17/2026

Job #: 17070111

Job Requirements and Properties

Help for Job Requirements and Properties. Work Onsite

Full Time Education

High School Diploma or Equivalent Experience

24 Month(s) DL

Required Schedule

Full Time Job Type

Regular Duration

Permanent Employment Benefits Help for .

Send Resumes:

yes

Interviews:

yes

Work Schedule:

Day shift Mon-Fri 6am- 3pm

NIGHT SHIFT

Mon-Thur Nights 3pm- 2am

Type of Opportunity/Length:

Temp-hire (Normally 90 Day probation period)

Pay Rate:

Up To $20-28/hr : TruBlu HR Solutions is seeking a Welder with minimum 2 years of experience. Must be able to read and understand blueprints, follow engineered drawings, pass

MIG/ TIG

welding test, operate a forklift, and review work for accuracy. Must be able to lift 40 lbs and work in a non-climate controlled environment.

Attire:

work pants/steel toe boots Manager Feedback - Welder Position (TruBlu HR Solutions) The department works almost exclusively with sheet metal aluminum, typically .090" to 3/16", primarily used for enclosures.

Candidates must:

Have a minimum of 2 years of welding experience

Be able to read and understand blueprints

Follow engineered drawings

Pass MIG and TIG weld tests

Operate a forklift

Review work for accuracy

Be able to lift 40 lbs

Work in a non-climate controlled environment Weld Process-Low Heat Mig-using short-circuit mode with small-diameter wire (0.023 or 0.030) Tig-using thin (1 mm or smaller) sharpened tungsten for low heat spread is the best to produce low heat spread

Tips:

run the thinnest wire possible; angle the heat toward the thicker metal Materials Sheet Metal/thin gauge metals -they will have to do tight fit ups and clamp very small precision parts

Inspection:

Visual/Destruction Heat inputAvoiding burn-through and warping Weld penetrationGetting enough fusion without over melt Appearance and distortionMinimal warping, clean beadsvisual test of clean fusions of metal Defect avoidanceNo undercut, porosity, or incomplete fusion