PC Test Technician Position Available In Miami-Dade, Florida

POSITION

PC Test Technician

IEMPLOYMENT STATUS

Non-Exempt

REPORTSTO

Supervisor,Testing

POSITION SUMMARY

• The PC Test Technician I is responsible for inspecting and testing electronic aircraft components on communication, navigation and flight control systems (ATC, ADF, TCAS, Audio).

PRIMARY RESPONSIBILITIES

• Conducts operational, environmental and stress testing procedures to ensure strict compliance with Gables Engineering’s Quality standards. Tests include
• Visualinspection-Continuitytests-Functionaltests-Lightingtests
• Utilizes test equipment to monitor and simulate transmission of data along ARINC 429 and CSDB signals
• Documents test results via acceptance test reports ensuring UUT has complete testing documentation and is ready for inspection
• Diagnoses the cause of malfunctions, identifies failures, and performs basic repairs of defective components based on analysis of test results
• Participates in audits conducted by clients and Federal Aviation Administration personnel as necessary

JOB SKILLS REQUIRED

• Strong electronic theory and troubleshooting skills (component level
• Ability to read and interpret drawing, schematics, and technical manuals
• Knowledge of various test equipment to include multimeters, oscilloscopes, and other special avionic test equipment tosupport environmental testing
• Good organizational skills and the ability to support several projects and engineers while balancing priorities and schedules as necessary
• Strong interpersonal skills and ability to communicate well with employees at all levels

REQUIRED EXPERIENCE

• A.S. degree in electronics or equivalent military/technical trade experience
• Minimum 1 year of electronic experience (avionics preferred)

PHYSICAL REQUIREMENTS

• Light Work
• This role may require exerting up to 20 pounds of force occasionally and/or up to 10 pounds of force frequently to lift carry, push, pull or otherwise move objects. Most essential functions are performed while sitting but walking and standing is occasionally required
• Manual dexterity is required in the assembly or fabrication of parts which may result in the repetitive motion of the wrists, hands, and fingers.
• Visual acuity is required for visual inspection of boards involving small defects, small parts, using measurement devices; and/or assembly or fabrication parts at distances close to the eyes.

###### Gables Engineering is a drug free workplace and Equal Opportunity Employer M/F/V/D.